How To Use - Toto REAH03B1U Manual De Instalación Y Del Propietario

1) Fill the tank with water
1. Turn on the water supply at the stop valve and inspect all the connections for any
leaks.
2. Insert the power plug.
Insert the power plug firmly and completely into
NOTE
the outlet.
After the power is turned on, water will flow for 5 seconds.
Please confirm
The "HEAT" light is off.
3. Press "TANK FILL".
When the power is turned on, startup may take some time. After inserting the power
NOTE
plug into the outlet, please wait about 10 seconds before pressing the "TANK FILL"
switch.
Please wait 3 minutes until the tank is full.
4. When the tank is full, press "TANK FILL" again
to stop the water.
• If the flow of water stops before
the water stabilizes, please press
the "TANK FILL" switch again, to
stabilize the flow of water,and fill
the tank.
NOTE
• After the tank is full, press "TANK
FILL" to remove debris from the
supply hose and tank, and let the
water flow from the spout for 5-6
minutes.
Please confirm
There should be no water leaking from the supply
hose
Check that no water is leaking from the supply hose or
spout tube connections.
water heater, rotate the central
concave portion to the left.

HOW TO USE

Opening and
shutting tool
Light off
18
1 1
開
Shutoff valve
2.Insert 2.Insert
3 3
3 4