2. Fit the sensor connector into the
groove of the connector box to secure it.
3. Close the connector box.
3) Install the top cover
< With left supply hose/sensor wire outlet >
• When mounting the Top cover, make sure that the cord does not become tangled.
• Please take care when cutting so as not to damage the Top cover.
• Please be careful of the burrs to prevent injury due to sharp edges.
NOTE
• Cut the first and last tabs on the side of the top cover (supply hose/sensor wire side)
and break firmly with band.
• Repeat for top portion of top cover for spout hose opening.
INSTALLATION PROCEDURE
Remove the burr of the
cut portion with
snippers. (10 places)
*Be careful not to warp
Top cover
the cover.
Groove:
Upper boundary
< With right supply hose/sensor wire outlet >
Top cover
17
Sensor cord
(Connector: White)
Connector box