Toto REAH03B1U Manual De Instalación Y Del Propietario página 13

Mounting on the wall
Use the instructions applicable to the type of wall.
< When mounting to tile or concrete wall >
Drill a pilot hole where instructed and insert wall anchors.
< When mounting to wood stud wall or hollow wall >
Confirm that the structure can withstand the weight (13.2lbs (6kg)) of the product when filled with water.
Secure the Mounting bracket with two wood screws, and secure the Anchoring plate with one wood screw.
Provide blocking and thoroughly reinforce the structure of the wall as needed.
3. Secure the anchoring plate to the Controller with one countersunk tapping screw.
• Please tighten by hand without using a power tool.
NOTE
• Please do not confuse the front and back of the Anchoring plate. Do not damage
the power cord.
Anchoring plate
Countersunk
tapping screw
4.  P ut the Mounting bracket in position
and secure it with two wood screws.
5. Hook the Controller on the Mounting
bracket and secure the Anchoring
plate with one wood screw.
• Please mount the unit
so that it is level.
• Please take care so that
NOTE
the power cord does not
become tangled or snag
the edge.
INSTALLATION PROCEDURE
Anchoring plate
Front Back
Countersunk tapping screws
(5/32"×25/64"(4×10))
Controller
Wood screw
(13/64"×1-1/4"
(5.1×32))
13
(Scale: inch(mm))
Controller
(Back surface)
Do not use power tool
Wall anchor
Wood screw
(13/64"×1-1/4"(5.1×32))
Mounting bracket
Anchoring plate
Wall anchor