Maintenance Instructions; Moving And Storage Instructions; Troubleshooting - Schumacher Electric INC100 El Manual Del Propietario

NR means that the charger setting is NOT RECOMMENDED.
Find your battery's rating on the following chart and note the charge time given for each charger
setting. The times given are for batteries with a 50 percent charge prior to recharging. Add more time
for severely discharged batteries.

12. MAINTENANCE INSTRUCTIONS

12.1 Before performing maintenance, unplug and disconnect the battery charger (see sections 5.8
and 6.7).
12.2 After use, unplug the charger and use a dry cloth to wipe all battery
corrosion and other dirt or oil from the terminals, cords, and the charger case.
12.3 After every 100 hours or whenever you see dust accumulating on the fan
blades, you should clean both fans using compressed air (as shown). NOTE:
Use the compressed air on the fan blades only. Do not blow dirt into the fan
shaft or bearing. These fans push a lot of air and are precision balanced.
Excessive dirt and grime buildup will cause the fan to be unbalanced and
wear out quickly. If the fans fail, the charger may overheat and the thermal
protection of the charger will shut it down.
12.4 Ensure that all of the charger components are in place and in good working condition, including
the plastic boots on the battery clips.
12.5 Servicing does not require opening the unit, as there are no user-serviceable parts.

13. MOVING AND STORAGE INSTRUCTIONS

13.1 If the charger is moved around the shop or transported to another location, take care to
avoid/prevent damage to the cords, clips and charger. Failure to do so could result in personal injury
or property damage. Do not store the clips on the handle, clipped together, on or around metal, or
clipped to cables.
13.2 Store the charger unplugged. The cord will still conduct electricity until it is unplugged from the
outlet.
13.3 Store inside, in a dry, cool place (unless you're using an on-board marine charger).

14. TROUBLESHOOTING

PROBLEM
No display and the LEDs are not
lit.
POSSIBLE CAUSE
Charger is not plugged in.
No power at the receptacle.
SOLUTION
Plug the charger into an AC
outlet.
Check for open fuse or circuit
10 / 115