Attaching The Fan Blades; Installing The Led Light Kit Assembly - Kichler 300032 Manual De Instrucciones

ATTACHING THE FAN BLADES

Step 1: Attach the fan blades to the flywheel using the blade screws and tighten
them securely. (Fig.13)

INSTALLING THE LED LIGHT KIT ASSEMBLY

NOTE: Before continuing installation, confirm that the power is still turned off at
the main circuit breaker or by removing the circuit fuse. Turning the power off
using a wall switch is not sufficient to prevent electrical shock.
Step 1: Hold the LED light kit assembly close the motor and connect the pin
connectors together. (Fig. 14)
NOTE: The two connectors have keyholes that must be mated correctly before
they can be engaged.
Step 2: Tuck the connections neatly into LED light kit assembly, raise the LED
light kit assembly up to the motor and twist screws to the narrow end of the
slotted holes on the motor. Make sure all screws lock in place and no longer
turns. (Fig. 14)
12 | KICHLER.COM
Blade Screw
Fig. 13
Fig. 14
Blade
LED Light Kit Assembly