Coloured Rail; Bent Rail - Harken Industrial R27 Manual De Instrucciones

Angled wall mount
An angled wall mount must be limited to a maximum
of 15° off vertical. The rail must be mounted so that the
load on the shackle is taken no more than 15° beyond
vertical. Exception, use trolleys with wheeled toggles
for greater angles.
NOTE!
For optimum trolley performance on the rail, we recommend
to place the rail so that the load is perpendicular
to the sliding plane of the trolley on the rail.

Coloured rail

The standard rail is supplied in (CLEAR) anodized aluminium colour. Aluminium rail can be supplied with powder
coating or anodizing coloured, on request. For more information, contact Harken.

Bent rail

The rail can be installed on bent surfaces, which have a minimum bending radius of 15 m. The bending rail
can be done manually in the 3 directions during the installation procedure.
1
2
3
For bending radius included between 2,75 m and 15 m in all the three direction, it's possible to require
the bending rail to Harken. The bent rail has 25 cm of straight rail at the extremity due to the production process.
For more information contact Harken.
24/07/20 ENGLISH
Sliding plane
13