Preliminary And Periodical Checks - Harken Industrial R27 Manual De Instrucciones

PRELIMINARY AND PERIODICAL CHECKS

Installing IN9561.CLEAR endstops
Fasten endstops to rail ends using fleathead M8 (5/16") stainless steel fasteners. Drill a M8 threaded hole in the
rail centerline and tap into the rail to mount end stop. Note hole center locations below and plan endstop location
on rail to avoid interference from the predrilled mounting or pinstop holes. Endstops must be mounted no farther
than 50 mm from the last fastener fixing rail to structure. Use an anticorrosion paste on the endstop fastener head
to prevent galvanic corrosion between fastener and rail.
PRELIMINARY AND PERIODICAL CHECKS
Before using the R27 rail, check its condition and visually check each component:
• Check rail for dirt buildup. If the rail has visible dirt or feels gritty, clean the rail ahead of your trolley as part of
your maintenance.
• Make sure that: the system components are not deformed, the screws are not loose, there are no signs of wear,
corrosion and build up of dirt. In case of identified faults or damaged parts, do not use the system.
• In particular, check the most critical components: connectors, fasteners and (mobile/fixed) end fittings.
WARNING!
If all screws are not fastened securely, rail can separate from mounting surface resulting in a fall,
severe injury, or death.
• Check to make sure screws have not loosened and
are flush with top of rail so trolleys roll smoothly.
Loose screws can also compromise system safety.
Inspect the rail by running the trolley assembly the
entire length without load. Ensure the trolley
assembly runs freely and hits no screw heads or
obstructions.
18 ENGLISH
IN9561.CLEAR
24/07/20