Harken Industrial R27 Manual De Instrucciones página 19

• Check to make sure that endstop screws of the
IN9561 endstop have not loosened. Screws must be
flush with the top of the endstop.
• Check to make sure that pinstop of the IN1642.CLEAR
endstop is securely fastened to a pinstop hole in the
rail. The bottom of the knob must be nearly flush with
the body of the endstop.
WARNING!
If endstop screws loosen or failure
to seat in a pinstop hole, trolleys can
roll off end of rail resulting in a fall, wich
could cause severe injury or death.
• Visually check that the supporting structure (where the fall arrest system is installed) does not show signs of
deterioration
• In case of faults or damaged parts, contact the safety officer, who will call Harken or Harken dealers's
authorized personnel or qualified personnel to inspect the system.
• In case of a fall, request an inspection of the fall arrest system to Harken or Harken dealers's authorized
personnel or to qualified personnel.
WARNING!
Any rail which has been subjected to the forces of arresting a fall or there is any doubt arise
about its condition for safe use, must be immediately withdrawn from use and not used again
until confirmed in writing by an Harken dealers's authorized personnel or qualified personnel to
inspect the system that it is acceptable to do so.
• In case of lightning, fires or intense weather events, do not use the fall arrest system and call Harken or Harken
dealers's authorized personnel or qualified personnel to inspect it.
• Check the legibility of the rail markings.
24/07/20 ENGLISH
CORRECT
INCORRECT
19