Changing The Basic Settings; Basic Settings; Care And Cleaning; Cleaning Agents - NEFF C57W40N3 Instrucciones De Uso

Checking, correcting or deleting settings
To check your settings, press the
1.
repeatedly until the corresponding symbol lights up.

Changing the basic settings

Your appliance has various basic settings which you can
change at any time.
Basic setting
Audible signal duration:
™‚
= short = 10 seconds
‚
Button tone:
™ƒ
= on
‚
Press the main switch. The appliance is ready for operation and
the symbol lights up.
~
Press and hold the button for a few seconds.
o
1.
The first basic setting appears on the clock display.
Press the button repeatedly until the required basic setting
o
2.
is shown.

Care and cleaning

With careful care and cleaning your microwave oven will retain
its looks and remain good order. We will explain here how you
should care for and clean your appliance correctly.
:
Risk of short circuit!
Never use high-pressure cleaners or steam cleaners to clean
the oven.
:
Risk of burns!
Never clean the appliance immediately after switching off. Let
the appliance cool down.
Notes
Slight differences in colour on the front of the appliance are
■
caused by the use of different materials, such as glass,
plastic and metal.
Shadows on the door panel which look like streaks, are
■
caused by reflections made by the oven light.
Enamel is baked on at very high temperatures. This can
■
cause some slight colour variations. This is normal and does
not affect their function. The edges of thin trays cannot be
completely enamelled. As a result, these edges can be
rough. This will not impair the anti-corrosion protection.
Unpleasant odours, e.g. after fish has been prepared, can be
■
removed very easily. Add a few drops of lemon juice to a cup
of water. Place a spoon into the container as well, to prevent
delayed boiling. Heat the water for 1 to 2 minutes at
maximum microwave power.

Cleaning agents

To ensure that the different surfaces are not damaged by using
the wrong cleaning agent, observe the information in the table.
Do not use:
any caustic or abrasive cleaning agents,
■
metal or glass scrapers to clean the glass in the appliance
■
door,
KJ clock function button
Options
Audible signal duration:
= medium = 2 minutes
ƒ
= long = 5 minutes
„
Button tone:
= off
ƒ
If necessary, you can correct your setting using the rotary
2.
selector.
If you wish to cancel your setting, turn the rotary selector anti-
3.
clockwise to the original value.

Basic settings

In the table, you will find all the basic settings and options for
changing them.
Explanation
Signal after the cooking time has elapsed
Confirmation tone when a button is pressed
Make the desired setting using the programme selector.
3.
Finally, press and hold the
4.
All settings are applied.
You can change the settings at any time.
metal or glass scrapers to clean the door seal,
■
hard scouring pads and sponges,
■
cleaning agents with high concentrations of alcohol.
■
Rinse out new sponge cloths thoroughly before use.
For easier cleaning, you can switch on the oven light. Open the
appliance door to do so.
Area Cleaning agents
Appliance front Hot soapy water:
Clean using a dish cloth and then dry
with a soft cloth. Do not use glass clean-
ers or metal or glass scrapers for clean-
ing.
Stainless steel Hot soapy water:
Clean using a dish cloth and then dry
with a soft cloth. Remove traces of
limescale, grease, starch and albumin
(e.g. egg white) immediately. Corrosion
can form under such residues. Special
stainless steel cleaning agents can be
obtained from the after-sales service or
from specialist retailers.
Cooking compart- Hot soapy water or a vinegar solution:
ment made of stain- Clean using a dish cloth and then dry
less steel with a soft cloth.
If the oven is very dirty: use oven
cleaner, but only when cooking com-
partment is cold. It is best to use a stain-
less-steel sponge. Do not use oven
spray or other aggressive oven cleaners
or abrasive materials. Scouring pads,
rough sponges and pan cleaners are
also unsuitable. These agents scratch
the surface. Allow the interior surfaces
to dry thoroughly.
button for a few seconds.
o
27