Serpento YARA 200 Manual De Usuario Y Mantenimiento página 43

• YARA 200
MANUAL DEL USUARIO
Open the throttle grip 1/8~1/4,then push the starter switch or foot starter lever.the choke lever is under the fuel tank, turn the choke lever to
complete close when cold start,when the engine begin to work, return the choke lever to the benginning position right now.
To hot the engine in the speed 1400r/min,until the choke lever turn to complete open,so that the engine will work normally.
WARNING:In the lowest temperature's place, before starter, use the foot starter lever stir the Bent stalk, twist the ignition switch
to"OFF"to close choke lever ,then to open throttle.
Engine break-in
Your new motorcycle drive during the beginning1000Km, don't make the engine bear too much Load, and make sure any gear lowers the best
speed's eighty percent, to avoid the throttle grip open Completely, and choice change speed, in order to release the engine bear too much
load. in the beginning period make the engine break-in turning, after breaking-in, all engine components will be repaired, all adjustments will be
restored, it will ensure optimum service life and performance from the engine.
Motorcycle driving
1. After the engine has been warned up, the motor- cycle is ready for riding.
2. W hile the engine is idling, pull in the clutch lever and tread the gearshift pedal to shift into its (low) gear.
3. Slowly release the clutch lever and at the same time gradually increase engine speed by opening the throttle. Coordination of the throttle with
clutch lever will assure a smooth and positive start.
4. When the motorcycle attains a steady speed, close the throttle, pull in the clutch lever and shift to 2nd gear by treading the gearshift pedal.
5. Coordinate the throttle with brakes for smooth deceleration.
6. Both front and rear brakes should be used at the same time and should not be applied strongly enough to lock the wheel, or braking
effectiveness will be reduced and control of the motorcycle be difficult.
15