Serpento YARA 200 Manual De Usuario Y Mantenimiento página 48

20
Make the motorcycle stand with main stand, using hand pull the drive chain, and Using hand Press the chain in the
middle of the two chain wheel, and examine.
The drive chain tension. Adjust the chain tension to about 10~20mm.
Adjustment of drive chain
Loosen the rear wheel axle nut(2)looser the chain adjusting nut(3),to assist you in performing this each chain adjuster which is to be aligned. W
ith each other and to be used as a reference from one side to the other.
(1) drive chain (2) rear wheel axle nut
(3) chain adjusting nut (4) the mark of number