Serpento YARA 200 Manual De Usuario Y Mantenimiento página 51

• YARA 200
MANUAL DEL USUARIO
Battery maintenance
1.Using new battery
1.1Adding electrolyte
1.1.1Inspect battery appearance and make sure that there are no cracks, cuts on it and no damages on the battery terminal.
1.1.2Open the plug for filling the electrolyte.
1.1. 3 The specified electrolyte is stored in a bottle. Open the bottle and connect with plastic hose, and then fill the electrolyte into the battery
up to UPPER LEVEL. After filling electrolyte, wait for 20 minutes. Refill to UPPER LEVEL if electrolyte level goes down.
NOTE:Do not overfill electrolyte over the UPPER LEVEL.
1.1.4 The motorcycle can start off after 30 minutes after filling electrolyte. It is best to charge the battery for 3 to 5 hours before using as it can
ensure maximum performance and extend battery life, especially in win ter or kept for a long time.
1.1.5 Fasten plug. Mop up the spilt electrolyte.
1.2 Installation
1.2.1 Connect the battery exhaust hose with battery . Make sure the connection correctly without any damage or it may result in explosion of
battery, split electrolyte to damage your clothes and motorcycle.
1.2.2 When assemble,(+)positive terminal first(with red mark), then (-)negative terminal.
NOTE: Make sure install positive and negative ter minal correctly. Incorrect installation of the battery will reserve the terminal position
resulting in ignition switch and possible regulator/rectifier electrical system damage.
1.2.3 Fasten bolts and add butter or Vaseline on the bolts, nuts and terminals or to prevent them from rusty or poor lead connection.
23