Base Lubrication - Stryker MX-PRO R3 Manual Del Usuario

BASE LUBRICATION

NOTE
MX-PRO has been designed to operate without the need for lubrication. Tri-Flow t
The
with TeflonR lubricant may be used to reduce the force required to raise the undercarriage and to minimize
wear. Do not use silicone, WD-40t, or lithium grease. They could harm the moving parts of the cot.
FOOT END
B
APPLY LUBRICATION
A
1. Place the cot in the highest position.
2. Turn the cot upside down with the base legs facing up.
3. Using the plastic applicator tube, spray Tri-Flow t with TeflonR lubricant (Stryker part number
6082-199-12) in the gap between the upper (item A) and lower lift tubes (item B) on both foot end legs.
4. Apply Tri-Flow to right and left height adjustment Height Adjustment Racks racks providing an even ap‐
plication.
5. Apply Tri-Flow to the right and left slide plates providing an even application.
6. Let the cot sit for 5 minutes.
7. Turn the cot back over. Raise and lower the cot a few times to work the lubricant throughout the applied
areas.
8. Wipe any excess lubricant from the base tubes. Slide plates.
Preventative Maintenance
Figure 37 - Base Lubrication Locations
1-37