Side To Side Positioning Of The Safety Hook; Installing The Safety Hook - Stryker MX-PRO R3 Manual Del Usuario

SIDE TO SIDE POSITIONING OF THE SAFETY HOOK

1. Remove the cot from the fastener and unload it from the vehicle.
2. While the cot is being removed, note the position of the load wheels and the safety bar.
3. Mark the center of the cot safety bar on the vehicle floor.
4. Verify that the position marked in Step 3 is where the safety bar engages the safety hook every time when unloading
the cot in a variety of positions (all the way to the left and all the way to the right), regardless of cot position.
• If the cot safety bar does not engage the safety hook in any of these positions (left, center, or right), modify
the vehicle, not the cot or safety hook.
• If the cot safety bar engages the safety hook every time, install the safety hook.

INSTALLING THE SAFETY HOOK

1. Determine the correct safety hook front to back and side to side positioning, so the cot safety bar engages the
safety hook every time.
2. Drill the holes for the socket head cap screws.
3. Fasten the safety hook to the patient compartment floor and verify that the safety hook always engages the cot
safety bar regardless of how the cot is unloaded from the vehicle.
WARNING
Verify that the safety hook always engages the cot safety bar regardless of how the cot is unloaded from the vehicle
or injury to the patient or operator and/or damage to the cot may occur.
Top View of Vehicle
Safety Hook
Door Frame
Safety Hook Placement
(For Reference Only)
WARNING
The cot must have at least 5/8" of clearance between the vehicle bumper and the cot to disengage the safety bar when
unloading the cot from the vehicle. Verify that the cot legs lock into the load position before disengaging the safety
bar from the safety hook. Failure to properly lock the cot into position can cause injury to the patient or operator and/
or damage to the cot.
Vehicle Safety Hook Installation
Bumper
Safety Hook
Floor Edge
Safety Bar Engaging Safety Hook
1- - 13
Safety Bar