Tripp-Lite PINV2000 Manual Del Propietário página 13

Mounting
2
The following mounting dimensions* should be used when
installing the remote to a permanent mounting location:
Ø
3
Using the center-to-center spacing of the mounting holes, mark
the locations for installation.
4
Secure the remote to its permanent location with user-supplied
hardware. Tighten by hand to reduce the possibility of cracking
the remote module at its mounting points.
5
Connect the remote's wired connector to the inverter's RJ11 port
labeled "REMOTE".
6
Set the inverter's main power switch to the REMOTE (||) position.
7
Test the connection and operation by pressing ON/OFF until the
green status LED shows on the remote module.
*All mounting dimensions are accurate to +/- 0.1 inch (2.5 mm).
18-11-135-9338A1.indb 13
2.539 in. (65 mm)
0.157 in. (4 mm)
STATUS
ON/OFF
PINVRM
1.269 in. (32 mm)
Ø
13
0.104 in. (3 mm)
0.492 in. (13 mm)
12/6/2018 3:02:47 PM