Operation; Operating Modes - Tripp-Lite PINV2000 Manual Del Propietário

Operation

Operating Modes

After mounting and connecting your Inverter according to the
instructions in this manual, use the ON/OFF/REMOTE switch to choose
the Inverter's operating mode.
ON: When you set the switch to the ON (I) position, the Inverter
provides AC power to connected equipment by converting DC power
from your vehicle's battery. The green LED will illuminate to indicate it
is working.
OFF: Set the switch to the OFF (O) position to shut down the Inverter
completely. Doing this will prevent it from drawing power from your
vehicle's battery. Also set the switch to the OFF position to reset the
Inverter if it has shut down due to low battery, overload or other critical
condition.
REMOTE: When you set the switch to the REMOTE (II) position, the
Inverter provides AC power to connected equipment by converting
DC power from your vehicle's battery. The green LED will illuminate to
indicate it is working. You can then power the inverter ON/OFF from a
remote location via the included PINVRM remote. This remote switch
can be mounted in the vehicle or a permanent mount application (see
Mounting section for more information). The green LED on the remote
will illuminate to indicate the inverter is in the ON operating mode.
1. Connect the Inverter (see Battery Connection section).
18-11-135-9338A1.indb 18
18
STATUS
ON/OFF
PINVRM
12/6/2018 3:02:49 PM