Dräger Oxylog Instrucciones De Uso página 16

English
Installation
WARNING
The all-round wallholder must only be mounted on the wall
by expert technicians.
WARNING
The Quick Power Connector must only be mounted on the
all-round wallholder by expert technicians.
WARNING
For fixing, only use the screws and fixing material as
indicated in these instructions for use.
Attaching the optional Quick Power Connector to
the all-round wallholder
Fixing material
– Screws supplied with the Quick Power Connector:
Four 4 x16 mm self-tapping countersunk head screws
– Self-adhesive insulation foil, supplied with the Quick Power
Connector
Tools
– Screwdriver
Mounting the Quick Power Connector
1 Stick the insulation foil (A) to the front of the all-round
wallholder. Make sure that the foil is correctly positioned as
shown in the illustration.
2 Position the Quick Power Connector in such a way that all
ridges fit precisely into the cut-outs (B).
3 Fasten the Quick Power Connector at the rear of the all-round
wallholder using the 4 screws (C).
16
A
B
Mounting the all-round wallholder on a wall
Fasten the all-round wallholder to a wall using the appropriate
fixing material.
Mounting holes
– 8 x 6.5 mm diameter
Fixing material
– 8 x M6 screws/bolts – ISO 4762 or equivalent
– 8x washer
WARNING
Only mount the all-round wallholder on flat and stable walls
and use all 8 mounting holes, otherwise the all-round
wallholder may come loose.
CAUTION
The installation position of the all-round wallholder must be such
that there is sufficient space for removing the carrying system.
1 To facilitate mounting, first insert the 2 screws/bolts with
washers halfway through the upper holes on the wall, without
the all-round wallholder in place.
2 Hang the all-round wallholder on the 2 screws/bolts with
washers.
3 Fasten the remaining 6 screws/bolts and washers.
When doing this, mount the 2 spring steel sheets (A) to the all-
round wallholder with the same screws that are used to attach
the all-round wallholder to the wall.
4 Tighten the 2 upper screws/bolts of step 1.
Instructions for use All-round wallholder
C