Dräger Oxylog Instrucciones De Uso página 19

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 33
Removing the Caddy, CompactCaddy, or Carrying
System
Reprocessing
Safety information
These instructions apply to the all-round wallholder and the Quick
Power Connector only.
To clean and disinfect a carrying system or Oxylog, refer to the
respective instructions for use.
WARNING
Risk due to inappropriately reprocessed products
Reusable products must be reprocessed, otherwise there is
an increased risk of infection.
Follow the infection prevention policies and
reprocessing regulations of the health-care facility.
Follow the national infection prevention policies and
reprocessing regulations.
Use validated procedures for reprocessing.
Reprocess reusable products after every use.
Follow the manufacturer's instructions for cleaning
agents, disinfectants, and reprocessing devices.
Instructions for use All-round wallholder
1
Push the release lever to the rear.
2
Remove a carrying system by lifting it up.
WARNING
Risk of disconnecting the hose connection
When removing a carrying system from the all-round
wallholder, check whether the hose connection with the
central gas supply system is still attached.
CAUTION
Risk of injury
Do not place fingers between the release lever and the hinged
locking system.
CAUTION
Risk due to faulty products
Signs of wear, e.g., cracks, deformation, discoloration, or peel-
ing, may occur with reprocessed products.
Check the products for signs of wear and replace them if neces-
sary.
Information on reprocessing
Follow the national infection prevention policies and reprocessing
regulations.
Follow the infection prevention policies and reprocessing
regulations of the health-care facility (e.g., concerning the
reprocessing cycles).
Classifications for reprocessing
Classification of products
The classification depends on the intended use of the product.
English
19

Publicidad

Tabla de contenido
loading

Tabla de contenido