Dräger Oxylog Instrucciones De Uso página 17

A
Power supply via the optional Quick Power
Connector
The Quick Power Connector is an optional accessory of the all-
round wallholder. It allows Oxylog to be charged when the carrying
system is attached to the all-round wallholder with an Oxylog with
a Quick Power Connector, and when a power supply unit or a
converter for Oxylog is connected.
Operation
The all-round wallholder is intended for securing the
CompactCaddy, Caddy, or carrying system on a wall (e.g., in a
vehicle or on a hospital wall).
Instructions for use All-round wallholder
A
Establishing the power supply:
1 Connect the DC/DC converter or AC/DC power supply unit of
Oxylog to the connector on the right side of the Quick Power
Connector.
WARNING
For safety reasons, a fully charged battery must always be
installed, even when operating from an external power
supply.
WARNING
Ensure that the power cable cannot be accidentally
disconnected. Otherwise, there is a risk that Oxylog is not
charged properly.
The all-round wallholder has 2 support bars:
1 The upper bar is for the CompactCaddy
2 The lower bar is for the Caddy and the Carrying System
Placing a carrying system in the all-round
wallholder
NOTE
When placing a carrying system in the all-round wallholder,
make sure that there are no objects between the system and the
all-round wallholder (with or without Quick Power Connector).
Otherwise the carrying system may not be securely attached.
1 Place the bottom rim of a carrying system in the appropriate
bar of the all-round wallholder (see previous illustration).
Check that the bottom rim of the system is completely
positioned on the bar of the all-round wallholder.
2 Push the claw of the carrying system firmly and completely into
the all-round wallholder over the hinged locking system until it
reaches the stop.
English
17