Changing The Presser Foot - Toyota SUPER JEANS Serie Manual De Instrucciones

Tip: Selecting a needle suitable for the thread
Pass the thread to be used through the eye of the
needle, and then hold both ends of the thread to give
the thread slack so that the needle slides along it, as
shown.
If the needle does not catch, the needle and thread are a
good combination.
Since a needle that is too thick for the thickness of the
thread will result in poor-quality stitching, select the
needle with the smallest number possible, which will
not catch on the thread.
If the needle frequently catches on the thread or does
not slide along it, stitching of poor quality will be
produced. In this case, select a needle with a different
number or a different type of thread.
Needle
2
Thread

■ Changing the presser foot

CAUTION
●
Before changing the presser foot,
use the main power switch to turn
off the sewing machine. Not doing
so could cause an injury.
●
Before sewing, be sure to turn the
handwheel toward you slowly to
check that the needle does not
touch the presser foot. Not doing
so could cause an injury.
1
Press the presser foot holder lever in the
direction of the arrow to release the presser
foot.
1
2
2
Position the presser foot pin directly below the
groove in presser foot holder from the behind.
Lower the presser foot lever to secure the presser foot.
1
2
3
1 Presser foot holder
lever
2 Presser foot
1 Presser foot holder
2 Groove
3 Presser foot pin