Beginning Work With The Machine - diversey TASKI procarpet 45 Manual De Instrucciones

Cleaning methods
Notice:
The cleaning method is described in detail
in the "Methods Card".
Please contact your TASKI customer con-
sultant for further details.
Spray extraction
Spray extraction
Cleaning of a fabric cover with water jet from the spray nozzle
and simultaneous vacuuming of the dirty water. The fabric
cover is free from soiling on the surface and in the deeper lay-
ers of the carpet pile; long drying time.
Indirect method:
First spray cleaning solution, leave to soak, rinse with fresh
water in the second step and simultaneously vacuum the wa-
ter off.
Direct method:
Spray extraction with cleaning solution in one combined step.
Notice:
The black brush must be used for the
cleaning method spray extraction.
Encapsulation
Encapsulation
Cleaning of a fabric cover by applying a cleaning solution and
brushing it in. Drying binds the dirt which can then be removed
with a vacuum cleaner with a brush.
Notice:
The white brush must be used for the
cleaning method encapsulation.
Notice:
The hand tool can not be used for the
cleaning method encapsulation.
Notice:
The filter of the fresh water tank must be
cleaned after every use, see page .

Beginning work with the machine

Notice:
Please familiarize yourself with the proper-
ties of the carpet before you start cleaning.
Incorrect use of the machine and the
cleaning product may result in damage to
the carpet.
Attention:
Always wear slip-resistant shoes and ap-
propriate working clothes when working
with this device!
Cleaning start
• Move the foot pedal forward into the
working position.
This lowers the suction nozzle and
the brush.
• Operate the adjusting lever at the
machine handle and lower the guide
bar slowly until it is in a comfortable
working position.
Release the adjusting lever to lock
the guide bar.
Notice:
You may also work with freely movable
guide bar by locking the adjustment lever.
• Insert the plug into the mains socket.
• Switch on the machine (main switch).
• Set the desired function.
• I = Encapsulation (water, brush and
cleaning product)
• 0 = Work in (brush only)
• II = Spray extraction (water, brush
and suction motor)
Notice:
Hold the main cord in your hand.
Ensure that the main cord cannot come
into contact with the tool.
• Press the operating lever.
The brushes will thereby be set into
motion.
EN
69