Beginning Work With The Machine - diversey TASKI swingo XP-M IntelliSweep Manual De Instrucciones

• Fill water into the fresh water tank
(Flextank).
The upper red marking indicates the
max. permissible filling level.
• Tip the tank cover back into its original position and press
it down until it locks.
Dosing:
Attention:
Wear gloves, goggles and appropriate
(protective) working clothes when han-
dling chemical products!
Notice:
Use chemical products recommended by
Diversey only and always observe the
product information.
Caution:
Using unsuitable products (e.g. products
containing chlorine, acids or solvents) may
cause harm to health and severe damage
to the machine.
Dosing examples:
Information on the pack-
age of the product
0.5% 50ml for 10l
of water
1% 100 ml for 10l
of water
2% 200 ml for 10l
of water
3% 300 ml for 10l
of water
• Fill the dosing cup with a suitable product and pour the con-
tent into the fresh water tank. Repeat the procedure until
the required dosing is reached.
• When dosing is finished, the dosing cup will remain in the
tank.
Notice:
An automatic dosage (IntelliDose) is inte-
grated into this machine. You can find out
how to exactly operate the IntelliDose in
the corresponding instructions for use.
Notice:
Diversey recommends sustainable work-
ing by determination of the correct product
dosing quantity. Overdosing or underdos-
ing will lead to unsatisfactory cleaning re-
sults.
82
Tank capaci- Product vol-
ty ume per
tank filling
113l 0.5l
113l 1.1l
113l 2.2l
113l 3.3l
Pre-cleaning
Attention:
Remove any objects (wooden, metal parts
etc.) from the cleaning surface.
The objects could be catapulted by the ro-
tating tool, and thereby cause injuries to
people and damage to the environment.

Beginning work with the machine

Attention:
Always wear slip-resistant shoes and ap-
propriate working clothes when working
with this machine!
Notice:
Whilst operating the machine always keep
both hands on the steering wheel / driving
handle, so that safe operation is guaran-
teed.
Attention:
Start familiarization with the machine by
making your first driving attempts in a free
area.
Attention:
If there is a danger of falling objects during
use of the machine, the necessary safety
precautions must be taken or adhered to in
accordance with national regulations.
Attention:
Before starting work (in the work position),
check whether your field of vision is suffi-
cient to ensure safe working. EN 3411
must be adhered to.
An insufficient field of vision can make
work difficult and therefore impair safety
for the operator, machine and third parties.
Attention:
While working, note the maximum clear-
ance height for doors and underpasses,
which are shown on the warning sign on
the machine.
Notice:
When working in public buildings, the
warning light must be switched on.
• Switch the machine on.
The display lights up briefly.
Use the emergency stop
Attention:
When activating the emergency stop the
gas pedal / driving switch must be re-
leased as otherwise the stopping distance
increases to an impermissible length.