Technical Characteristics - Metrix DOX2025B Manual Del Usuario

Technical characteristics

Inputs
Input coupling
Input impedance
Max. voltage at input
Ch to Ch insulation
(both channels with the same
V/div configuration)
Probe attenuator
Probe attenuator
configuration factors
Vertical system
Vertical sensitivity
Range of variation of the
vertical position
Vertical resolution
Number of Channels
Analog bandwidth
Single bandwidth
Flatness of the Bandwidth
on the BNC input
Low frequency limit to -3dB
with AC coupling
Noise: Pk-Pk for a 3K
recording
SFDR with the harmonics
(measurement by FFT)
Accuracy of DC gain for
a signal of amplitude 6 div.
Accuracy of the DC
measurements:
all ranges: ≤100mV/div.
Accuracy of the DC
measurements:
all ranges: > 100mV/div.
Rise time
Overshoot (Typical)
(with pulse tr = 500ps)
Skew between channels
(same V/div range)
Math operation
Bandwidth
Two-channel digital Oscilloscopes
The oscilloscope must have operated continuously for thirty minutes at the service
temperature. You must run the Auto-calibration from the "Utility" menu if the service
temperature varies by more than 5°C. The oscilloscope must be within the factory
calibration range. All specifications are guaranteed except those marked "typical"
DOX2025B
>100:1 to 12.5MHz
0.1x,0.2x,0.5x,1x,2x,5x,10x,20x,50x,100x,200x,500x,1000x,2000x,5000x,10000x
DOX2025B
25MHz
25MHz
≤ 0.6 div. for a mean of 10 Pk-Pk readings, 2mV to 10V/div ranges
≤ 0.7 div. for a mean of 10 Pk-Pk readings, with fine adjustment of the range
± 4.0%: 5mV/div. to 10 V/div. in fixed gain ranges
± [3% * (|measurement| +|offset|) +1% * |offset| +0.2 div. +2mV]
± [3% * (|measurement| +|offset|) +1% * |offset| +0,2 div. +100mV]
< 7.0ns
<10% with probe or BNC input with 50 Ohm through termination
< 4ns
Type of Window: Hanning, Hamming, Blackman, Rectangular
FFT
(Note: The Bandwidth is limited to less than 10MHz when a probe is used at X1)
DOX2070B
AC, DC, GND
1 MΩ ±2% || 18 pF ±3 pF
300 V (DC+AC Pk) 300 Vmax CAT II
>100:1 to 35MHz
1X, 10X
DOX2070B
2mV/div. -10 V/div. (order 1-2-5)
2mV - 200mV: ±1.6V
206mV - 10V: ±40V
8 bit
2
70MHz
70MHz
DC-10% of the nominal BW: ± 1dB
10%-50% of the nominal BW: ± 2dB
50%-100% of the nominal BW: + 2dB/-3dB
≤ 10Hz
≥35dB
± 5.0%: 2mV/div. variable gain ranges
< 5.0ns
< 4ns
+, - , *, /, FFT
Number of sampling points: 1024
20MHz ± 40%
DOX2100B
>100:1 to 50MHz
DOX2100B
100MHz
100MHz
< 3.5ns
< 1ns
25