Kärcher MIC 70 Manual Del Usario página 76

9. Remove the wheel.
10.Clean any dirty wheel nuts and threaded studs.
11.Fit the new wheel and tighten all wheel nuts lightly all
the way to their end stops.
12.Tighten the wheel nuts in the specified order (A - E)
step by step.
13.Finally, tighten the wheel nuts in the specified order us-
ing a correctly working torque wrench to 180 Nm.
14.Pull out the safety stands and lower the vehicle with the
jack.
12.7.9Checking the engine oil level
CAUTION
Danger of burns
Allow the vehicle to cool down long enough so that there is
no longer a risk of burns.
Oil dipstick
1
1. Park the vehicle on a level surface.
2. Switch off the ignition and remove the ignition key.
3. Remove the right-hand side cover.
4. Pull out the oil dipstick.
5. Wipe the oil dipstick and insert it.
6. Pull out the oil dipstick.
7. Read off the oil level on the oil dipstick.
If the oil level is below the lower mark (MIN), top up the
engine oil.
12.7.10Topping up the engine oil
CAUTION
Danger of burns
Allow the vehicle to cool down long enough so that there is
no longer a risk of burns.
CAUTION
Risk of damage
An excessive high oil level leads to engine damage. If the
oil level is higher than the upper marking on the oil dipstick,
then oil must be drained until the correct oil level is
reached.
76
Screw for fuel tank
1
Fuel tank with handle
2
1. Remove the left-hand side cover.
2. Unscrew the screw for the fuel tank.
3. Pivot the fuel tank outwards using the handle.
Oil filler cap
1
4. Remove the oil filler cap.
5. Top up the engine oil.
For the engine oil specifications, see chapter .
Do not fill the engine oil above the "MAX" mark.
6. Check the engine oil level after 5 minutes.
Top up the engine oil if necessary.
12.7.11Changing the engine oil and engine oil filter
DANGER
Risk of burns from hot engine oil!
Allow the vehicle to cool down long enough so that there is
no longer a risk of burns from hot engine oil and the engine
oil filter.
Note
A warm engine facilitates the draining of engine oil.
1. Park the vehicle on a level surface.
2. Provide a catch pan for at least 10 litres of oil.
3. Switch off the engine.
4. Remove the oil filler cap.
5. Unscrew the oil drain plug.
6. Drain the engine oil.
7. Unscrew the engine oil filter.
8. Clean the mount and sealing surface.
9. Coat the seal of the new engine oil filter with oil.
10.Screw in the new engine oil filter and manually tighten
it sufficiently.
11.Renew the sealing ring for the oil drain plug and tighten
the oil drain plug to 60 Nm.
English