Cleaning The Vehicle - Kärcher B 300 RI LPG Manual De Instrucciones

Ocultar thumbs Ver también para B 300 RI LPG:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

9.8.2
Cleaning/replacing the flat fold filter
9.8.3

Cleaning the vehicle

Clean vehicle daily after finishing work.
DANGER
Risk of injury!
Wear dust mask and protective goggles.
CAUTION
Risk of damage!
Be careful when using high-pressure cleaners for
cleaning!
Radiator fins, hydraulic hoses and valves, seals and
electric and electronic components must not be
cleaned with the high-pressure cleaner.
When cleaning the vehicle with a high-pressure clean-
er, the respective safety instructions must be observed.
Do not use aggressive cleaning agents.
Only wash the vehicle while the motor is switched off to
protect the air filter.
Clean the machine with a damp cloth which has been
soaked in mild detergent.
Check motor for soiling; if necessary, clean by means
of a brush, compressed air or low water pressure
32
1 Nuts (4x)
2 Filter dedusting rail
3 Dust filter cartridges (5x)
Screw out 4 nuts.
Remove the filter dedusting rail.
Take out five dust filters and five sealing rings.
Clean the dust filter with compressed air from the out-
side to the inside.
During installation, take care to ensure that all sealing
rings are seated correctly in the guides.
ATTENTION
Do not use any hard objects for cleaning!
The flat fold filter is responsible for protecting the suction
blower of the wet cleaning.
Remove and clean the flat fold filter as needed.
Replace every 100 operating hours!
1 Lock
2 Sealing band
3 Cover, suction blower
4 Flat fold filter
Open the lock and lock strap.
Remove cover.
Take out the flat folded filter.
Clean under flowing water with a soft brush, allow to dry
before installation.
Ensure at the time of installation that the flat fold filter is
seated correctly in the guide.
31
-
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido