Check Engine Oil Level And Top Up, If Required; Change The Motor Oil And The Oil Filter - Kärcher B 300 RI D Manual De Instrucciones

9.5.3

Check engine oil level and top up, if required

9.5.4

Change the motor oil and the oil filter

neues Bild
66
1 Oil dipstick
2 Oil filler cap
Park the vehicle on a level surface.

Pull out oil dipstick.

Wipe off oil dipstick and insert.

Pull out oil dipstick.

9.5.3.1 Check the motor oil level
Read the value of the oil level.

Insert the oil dip again.

The oil level must lie between "MIN" and "MAX" marking.
–
Add motor oil if the oil level is below the "MIN" marking.
–
9.5.3.2 Fill in motor oil
ATTENTION
An oil level that is too high leads to damages of the engine
by overheating. If the oil level exceeds the "MAX" mark, oil
must be drained until the correct oil fill level has been
reached.
Remove the oil filler cap.

Fill in motor oil.

Oil grade: Refer to chapter "Technical data"
Do not fill oil above the "MAX" marking.

Close oil cap.

Wait at least 5 minutes.

Check engine oil level.

WARNING
Risk of burns!
To change the motor oil and motor oil filter, allow the

vehicle to cool down until there is no longer a risk of
burns.
1 Oil filler cap
2 Oil dipstick
3 Engine oil filter
Note
A warm motor facilitates the draining of the motor oil.
Prepare a collection container for at least 10 litres of oil.

Switch off engine.

Unscrew oil drain plug.

Remove oil cap.

Drain off oil.

Unscrew the oil filter.

Clean the intake and sealing areas.

Coat the washer of the new oil filter with oil before fitting it.

Fit in the new oil filter and tighten it by hand.

Screw in the oil drain plug with the new seal.

Tightening torque: Nm
Fill in motor oil.

For oil type and filling quantity refer to Chapter "Techni-
cal specifications".
Close oil cap.

Let the motor run for approx. 30 seconds.

Wait at least 5 minutes.

Check engine oil level.

Check for leaks.

Deliver the old oil to the respective collection centres.

25
-
EN