Assembling The Drive Shaft - RK Rose+Krieger MonoLine R Instrucciones De Montaje

Assembly
Assembling optional modules > Assembling the drive shaft
Assembling the adapter flange
Fig. 28: Assembling the adapter
flange

5.4.3 Assembling the drive shaft

Applicable to
Assembling the adapter washer
Fig. 29: Assembling the adapter
washer
102
10. Slide the adapter flange (Fig. 28/2) onto the pulley boxes/
intermediate plates (Fig. 28/1).
11. Tighten 4 screws each (Fig. 28/3), alternating diagonally:
Size
40
60, 80, 120 M8
12. Position the protective tube in the adapter flanges and fix
them using the set screws (Fig. 28/4).
ð The synchronisation shaft is assembled.
Version
Size
Personal:
Schutzausrüstung:
Prerequisite:
n The electric gear unit and/or motor (if available) are secured
against restarting.
1. Place the centring collar of the adapter washer (Fig. 29/2) on
the timing belt shaft (Fig. 29/3).
2. Tighten 4 screws (Fig. 29/1) alternating diagonally:
Size
40
80, 120
Linear unit RK MonoLine R/RK MonoLine Z
Screw size
M4
RK MonoLine Z
40/80/120
n Assembly staff
n Protective clothing
n Protective gloves
n Safety shoes
Screw size
M4
M8
Tightening torque [Nm]
3
25
Tightening torque [Nm]
3
40
26.03.2019