Pre Installation; Delivery Check; Installation Requirements - Nederman FlexFilter EX Manual De Instrucciones

EN FlexFilter EX
9
9.1
9.2
40
The key components of the Explosion Suppression System are:
• An explosion detection device (pressure/optical)
• Computer operated control unit
• Action elements such as pressure cylinders with extinguish agent
contained with an extra fast opening valve.
Detailed information regarding system function, operation and maintenance
can be found in the suppression system manual.

Pre Installation

WARNING! Risk of personal injury.
Risk for personnel injuries. Always use proper lifting equipment and protective
gear.
WARNING! Risk of personal injury.
Explosion risk. Don't open the connection box when explosive atmosphere or
dust is present.
NOTE! Always follow local regulations and legislations for all steps in the
installation process.
NOTE! Fill in the installation protocol during the installation.
NOTE! The explosion relief panel should be handled with great care. Never
poke at the pressure-sensitive membrane and do not bend the membrane or
the frame.
NOTE! Read the entire manual before assembly of the FlexFilter EX and pay
close attention to the recommendations. It is recommended that a layout is
made for the entire system before installing the FlexFilter EX.

Delivery check

The FlexFilter EX should be checked for any damage that may have occurred
during transport. If there is damage or parts missing, the carrier and your local
Nederman representative should be notified immediately.

Installation requirements

The location were the FlexFilter EX is to be placed must be prepared before
the installation. Choose which side that is to be used to access the Bulk-Bags
(see picture no. 13) A - front, B - rear. Consider the risk area (see chapter
9. Explosion protection) and the space required for a service platform or other
means of changing the filters and maintenance.
NOTE! The risk area may prohibit accessing the FlexFilter EX from the front.
NOTE! The FlexFilter EX needs approx 1000 mm of free space above the top to
facilitate the changing of main and control filters.