Alarm Messages - JVC BD-X201MS Manual De Instrucciones

LCD Display and On-Screen Content
On-Screen Content (continued)

Alarm Messages

Alarm messages are displayed on the DVD recorder's LCD display and on the monitor when the recorder cannot obey a com-
mand. These messages will remain on-screen until the next operation is carried out.
Monitor screen
REC INHIBIT
04/05/06
11:20:00 CHAPTER 01 0:11:22
LCD display
Monitor message
message
INVALID DISC INVALId dISC
NOT SUPPORT NoT SUPPoRT
DISC
REC INHIBIT REC INH
COPY INHIBIT CoPY INH
DISC FULL dISC FULL
CELL OVER CELL oVER
OVERHEATING! oVERHEATING
INVALID SYNC INVALId SYNC
ERRoR
FAN STOP FAN SToP
CAUTION
If alarm messages such as "INVALID DISC" are displayed several times when a disc recorded using this DVD recorder or a
blank disk is inserted, there is a possibility that the disc itself has been damaged. In such a case, the damaged disc should be
replaced with a new one.
If the alarm messages continue to appear after replacing the disc, the problem may lie within the DVD recorder, and in such a
case, you are recommended to contact either the store where this DVD recorder was purchased or your JVC authorized dealer.
E-20
All manuals and user guides at all-guides.com
000 min
Alarm messages:
Displayed
DISPLAY from the
DISPLAY MENU
screen is set to
ON.
REC
TITLE 01 0:11:22
A disc other than specified was inserted.
A disc recorded using a different DVD recorder was inserted or played.
• Recording was attempted using a disc on which no more data can be recorded.
• The current disc is a non-finalized disc to which no more data can be recorded.
Recording of a copy-protected signal was attempted.
All remaining space on the disc is used up during recording.
The number of cells for a single title exceeded 255.
This will be displayed when the recording time for a single title is exceeded as a
result of setting ENCODE QUALITY to a low quality, recording content with little
movement, or other similar factors.
Displayed when the internal temperature of the set rises due to fan malfunction, etc.
In this case, immediately turn off the power and discontinue use. The power will
automatically shut down in about 20 minutes after the OVERHEATING display.
This is displayed if recording is discontinued when signals are interrupted and out of
sync during recording.
This is displayed when playback or recording is stopped due to dirt or damage on the
disc. In this case, either clean the disc or replace it.
This is displayed when the fan stops.
when
Description
LCD display
Alarm message