Changing The Signal System (Ntsc / Pal); Operation Procedure - JVC BD-X201MS Manual De Instrucciones

Others

Changing the Signal System (NTSC / PAL)

This DVD recorder supports both the NTSC and PAL signal systems.
The signal system can be altered at the TV TYPE item on the SYSTEM(2/2) menu screen, or via the following procedure.
The signal system can be changed even when the monitor is not connected.

Operation Procedure

1.
Set this unit to the Stop mode.
2.
Press and hold the SETUP and STOP buttons simultaneously for approximately 3 seconds.
• This changes the signal system. When this is done, the unit will turn off automatically and rebooted.
This product uses partial third-party software.
For information concerning the software used, login via FTP by inputting the following into
the unit and view the readme.txt file:
User: anonymous
Password: None
(If the IP address of the unit is set to 192.168.0.2, FTP connection can be established by
entering ftp://196.168.0.2 in the address bar of Internet Explorer.)
E-80
All manuals and user guides at all-guides.com