Preparation; Connections - JVC BD-X201MS Manual De Instrucciones

Preparation

Connections

Audio and video signals
Audio output
Note 2
Input
Analog audio
DV
RS-232C
REMOTE
Note 6
Note 1: The video signal for input is selected using INPUT SELECT from the INPUT SELECT MENU screen.
Note 2: The audio signals for input are selected using INPUT SELECT from the INPUT SELECT MENU screen.
When either LINE or Y/C is set for INPUT SELECT, the analog audio signals from the AUDIO IN terminals will be
selected for input.
When DV is set for INPUT SELECT, the DV audio signals from the DV IN/OUT terminal will be selected for input.
Note 3: When the DVD recorder is in Stop or Recording mode, the video input signal is output on the E-E screen as a composite
video signal.
In addition, the Setup Menu and other setting screens are also displayed on the monitor connected to this terminal. The
DVD recorder's operation status and other relevant information are displayed on-screen when DISPLAY from the DIS-
PLAY MENU screen has been set to ON.
Note 4: The Y/C IN/OUT terminal's specification (i.e., S1 or S2) can be selected using Y/C TERMINAL MODE from the SYS-
TEM MENU (2/2) screen. The same information as with the VIDEO LINE OUT terminal is output from the Y/C OUT ter-
minal.
Note 5: The standard input level for audio signals input via the AUDIO IN terminals (i.e., +4 dB or –8 dB) can be selected using
the AUDIO INPUT LEVEL switch on the rear panel.
Note 6: Use the following cable as the DV cable.
VC-VDV204 (2m, 4P-4P) from JVC
VC-VDV206 (2m, 4P-6P) from JVC
All manuals and user guides at all-guides.com
Video output
Input
Composite
DV
YC separate
Note 4
DV IN/OUT Y/C IN LINE IN
DV IN/OUT
REMOTE cable
Note 1
Note 3
Composite
LINE OUT
Note 4
YC separate
Y/C OUT
Analog audio
AUDIO OUT
AUDIO IN
REMOTE
Note 5
USB
Monitor TV
Headphones
PHONES
(on front panel)
Stereo
Keyboard
E-21