Alarm Messages - JVC BD-X200E Instrucciones

LCD Display and On-Screen Content

Alarm Messages

Alarm messages are displayed on the DVD recorder's LCD display and on the monitor when the recorder cannot obey a command.
These messages will remain on-screen until the next operation is carried out.
Monitor screen
REC INHIBIT
04/05/04
11:20:00
Monitor message
INVALID DISC INVALID DISC
NOT X200 NOT X200
REC INHIBIT REC INH
COPY INHIBIT COPY INH
DISC FULL DISC FULL
CELL OVER CELL OVER
REGION CODE REGION CODE
OVERHEATING! OVERHEATING
CAUTION
If alarm messages such as "INVALID DISC" are displayed several times when a disc recorded using the BD-X200 or a blank
disk is inserted, there is a possibility that the disc itself has been damaged. In such a case, the damaged disc should be
replaced with a new one.
If the alarm messages continue to appear after replacing the disc, the problem may lie within the DVD recorder, and in such a
case, you are recommended to contact either the store where this BD-X200 was purchased or your nearest JVC authorized
dealer.
E-20
000 min
REC
TITLE 1 0:11:22
CHAPTER 1 0:11:22
LCD display
message
The current disc is not a DVD-R or DVD-RW.
A disc recorded using a different DVD recorder was inserted or played.
● Recording was attempted using a disc on which no more data can be recorded.
● The current disc is a non-finalized DVD-RW to which no more data can be recorded.
Recording of a copy-protected signal was attempted.
All remaining space on the disc is used up during recording.
The number of cells for a single title exceeded 255.
This will be displayed when the recording time for a single title is exceeded as a
result of setting ENCODE QUALITY to a low value (i.e., 4 Mbps or lower), recording
content with little movement, or other similar factors. No error will be triggered when
the time is within that set for the total content.
An attempt was made to play a disc for which a region code has been set.
Displayed when the internal temperature of the set rises due to fan malfunction, etc.
In this case, immediately turn off the power and discontinue use. The power will
automatically shut down in about 20 minutes after the OVERHEATING display.
Alarm messages:
Displayed when
DISPLAY from the
DISPLAY MENU
screen is set to
ON.
LCD display
DOLBY DIGITAL
LPCM MPEG
Alarm message
Description