Preparation; Signal Connections - JVC BD-X200E Manual Del Usuario

Preparation

Signal Connections

Audio and video signals
Audio outputs for VCR
Note 2
Input
Analog audio DV
DV IN/OUT
DV IN/OUT
Note 1: The video signal for input is selected using INPUT SELECT from the INPUT SELECT MENU screen.
Note 2: The audio signals for input are selected using INPUT SELECT from the INPUT SELECT MENU screen.
When either LINE or Y/C is set for INPUT SELECT, the analog audio signals from the AUDIO IN terminals will be selected
for input.
When DV is set for INPUT SELECT, the DV audio signals from the DV IN/OUT terminal will be selected for input.
Note 3: When the DVD recorder is in Stop or Recording mode, the video input signal is output on the E-E screen as a composite
video signal.
In addition, the Setup Menu and other setting screens are also displayed on the monitor connected to this terminal. The
DVD recorder's operation status and other relevant information are displayed on-screen when DISPLAY from the DISPLAY
MENU screen has been set to ON.
Note 4: The Y/C IN terminal's specification (i.e., S1 or S2) can be selected using Y/C TERMINAL MODE from the RECORDER
MENU (2/2) screen.
Note 5: The standard input level for audio signals input via the AUDIO IN terminals (i.e., +4 dB or –8 dB) can be selected using the
AUDIO INPUT LEVEL switch on the rear panel.
All manuals and user guides at all-guides.com
Video outputs for VCR
Note 1
Input
Composite
DV
YC separate
Note 4
Note 3
LINE OUT
Y/C IN LINE IN
VIDEO
IN LINE OUT
Y/C
IN
DV IN/OUT
USB
LAN
SIGNAL
GND
AUDIO IN
Note 5
Composite
Analog audio
AUDIO
INPUT CH1
LEVEL
IN OUT
4dB
8dB
AUDIO OUT
CH2
REMOTE
PHONES
DC 19V
(on front panel) Stereo
Monitor or TV
Headphones
同期信号発生器
E-21