Black 7/8" Machine Screw - Sauder 424192 Instrucciones De Montaje

Step 15
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the mounting
å
screw is against the stops as shown in the right diagram. If it isn't,
loosen the mounting screw to slide it against the stops. Then tighten
the mounting screw.
First, fasten the DOOR (J) with HINGES (40H) to the RIGHT
å
UPRIGHT (C). Use the screws in the HINGES. You should start each
SCREW a few turns before completely tightening any of them.
NOTE: Tighten the adjusting SCREWS completely in to center this
å
DOOR between the UPRIGHTS.
Fasten the DOORS (J) with CURVED HINGES (14H) to the ENDS (A and B).
å
Use the screws in the HINGES. You should start each SCREW a few turns
before completely tightening any of them.
Fasten a KNOB (178K) to each DOOR (J). Use three BLACK 7/8"
å
MACHINE SCREW (37S).
See the next step for additional
å
DOOR adjustments.

BLACK 7/8" MACHINE SCREW

(3 used for the KNOBS)
www.sauder.com/services
37S
B
Stop
Mounting
screw
C
J
DOOR (J)
with CURVED
HINGES (14H)
424192
Pro Tip: Lift with your
legs. And, you know,
your arms.
Adjusting
screw
Hinge
178K
OR
178K
A
J
J
DOOR (J)
with CURVED
HINGES (14H)
DOOR (J) with HINGES (40H)
Curved
edge
Page 19