Black 1-1/8" Machine Screw; Black 7/8" Machine Screw - Sauder Edge Water 418797 Manual Del Usuario

Step 15
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the mounting
å
screw is against the stops as shown in the right diagram. If it
isn't, loosen the mounting screw to slide it against the stops.
Then tighten the mounting screw.
Fasten a DOOR (I) to the RIGHT END (A). Use the screws
å
provided in the HINGES. See the next step for adjustments.
Fasten a KNOB (124K) and BACKPLATE (125K) to the DOOR (I).
å
Use a BLACK 1-1/8" MACHINE SCREW (21S).
Peel the FELT DISC from the FELT DISC CARD (1M). Stick a
å
FELT DISC on the DOOR where it comes in contact with the
RIGHT UPRIGHT (C).
Repeat this step for the other DOOR (I).
å
Page 20
A
C

BLACK 1-1/8" MACHINE SCREW

(2 used in this step)
418797
Pro Tip: Lift with your
legs. And, you know,
your arms.
Stop
Mounting
screw
Hinge
1M
124K
I
125K
21S
www.sauder.com/services