Black 1/2" Machine Screw - Sauder 420701 Manual De Instrucciones

Step 7
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper diagram below. Be
å
prepared, the parts are greasy.
Fasten six EXTENSION RAILS (1) to the ENDS (A and B) and UPRIGHTS (C and D). Use twelve BLACK 1/2" MACHINE
å
SCREWS (16).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the ENDS and UPRIGHTS. Turn
a SCREW into this hole.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
2
Push the black lever up and
pull the SLIDE from the RAIL.

BLACK 1/2" MACHINE SCREW

(12 used in this step)
A
420701
Open end
16
C
1
1
1
1
Open end
www.sauder.com
1
Use these holes.
D
1
B
1
Open end
Page 11