Disconnecting A Gas Cylinder - Pit Boss PRO Serie Montaje Y Operación

HOW TO PERFORM A LEAK TEST
Supplies Required:
Bowl ( empty, clean )
1 x
1 x Paint Brush ( clean )
Dish Washing Liquid
Water
Procedure:
1. Position the grill in a well-ventilated area. Ensure the grill is cool to the touch, and not in use. Verify that the regulator
value is turned to the OFF position and that the gas cylinder is tightened securely to the regulator.
IMPORTANT: Ensure there is no open flame or smokers nearby.
2. Mix a solution of one part of water with one part of dish washing liquid in a bowl. The solution will make bubble,
as it will be concentrated.
3. Use a paint brush to apply the solution onto the seal between the regulator and the gas cylinder. Visually inspect for
streams of bubbles coming from a defect or break in the seal.
NOTE: If a leak appears, repeat gas cylinder installation procedure, but do not over-tighten. Hand-tighten
only. Repeat leak test after re-installation to ensure seal is secure.
IMPORTANT: Do not use the gas grill if you detect a gas leak that cannot be corrected by using the leak test
procedure. Contact your local Fire Department or Customer Service for alternative measures of testing to
ensure proper precaution.

DISCONNECTING A GAS CYLINDER

1. Ensure the regulator valve on the grill is completely closed by turning the knob clockwise to the OFF position.
2. Turn the cylinder counter-clockwise (by hand) to disconnect from the regulator valve opening. Replace the protective caps
on the regulator valve opening and the top of the gas cylinder for storage (if not empty).
NOTE: If storing the grill indoors, leave the gas cylinder outdoors.
WARNING: Do not fold up or transport grill with gas cylinder attached. The cylinder may loosen off the
valve and cause a gas leak, possibly resulting in an explosion, fire, or severe bodily harm. Disconnect gas
cylinder first before travel or storage.
Never light your gas grill with the lid closed or before checking to ensure the burner tubes are fully seated over the gas valve orifices.
Electrical equipment provided with the outdoor cooking gas appliance shall have the following in the instructions:
• To protect against electric shock, do not immerse cord or plugs in water or other liquid;
• Unplug from outlet when not in use and before cleaning. Allow to cool before putting on or taking off parts;
• Do not operate any outdoor cooking gas appliance with a damaged cord, plug, or after the appliance malfunctions or has
been damaged in any matter. Contact the manufacturer to repair;
• Do not let the cord hang over the edge of a table or touch hot surfaces;
• Do not use an outdoor cooking gas appliance for purposed other than intended;
• When connecting, first connect plug to the outdoor cooking gas appliance then plug appliance into the outlet;
• Use only a Ground Fault Interrupter (GFI) protected circuit with this outdoor cooking gas appliance;
• Never remove the grounding plug or use with an adaptoer of 2 prongs; and
17