Connecting The Wheels To The Cart; Connecting The Caster Wheels To The Cart; Securing The Lid Stopper; Securing The Chimney - Pit Boss PRO Serie Montaje Y Operación

6. CONNECTING THE WHEELS TO THE CART

Parts Required:
Wheel (#33)
2 x
2 x Wheel Axle Pin (#G)
2 x Wheel Washer (#F)
2 x Wheel Cotter Pin (#E)
Installation:
• Attach the large wheel to the support leg by inserting the wheel axle pin
through the wheel. Support leg hole, then secure using the wheel cotter
pin. Repeat installation for the other wheel on same side.

7. CONNECTING THE CASTER WHEELS TO THE CART

Parts Required:
2 x Locking Caster Wheel (#32)
Installation:
• Insert each locking caster wheel into the bottom of each support leg by
hand-tightening into the hole. It will secure into the self-clinching nut.
Ensure the locking caster wheel is inserted completely by ensuring it
cannot rotate any further.
• Once the wheels are secure, lock the caster wheels, then using a second
person, carefully lift the grill into an upright position.
IMPORTANT: Re-tighten the support leg screws to ensure they are
completely secure after positioning the grill upright.

8. SECURING THE LID STOPPER

Parts Required:
2 x Lid Stopper (#8)
Installation:
• Secure the two lid stoppers onto the top of the main barrel using the pre-
installed screws on the top.

9. SECURING THE CHIMNEY

Parts Required:
Chimney Cap (#6)
1 x
Chimney Stack (#9)
1 x
3 x Screw (#A)
3 x Locking Washer (#C)
3 x Washer (#B)
3 x Nut (#I)
Installation:
• Locate the chimney opening on the backside of the gas barrel. From the
inside of the gas barrel, insert the chimney stack through the opening.
Insert a washer, locking washers, and screw into each hole from the outside
of the gas barrel, but fasten only half-way, Once all three screws are partially
installed, secure the screws completely.
10
6
33
G
F E
E F
33
7
32
8
8
9
6
A
C
B
9
I
G
8