Cleaning / Maintenance; Cleaning & Maintenance; 6�1 Changing Tips; 6�2 Changing The Cork Sleeve - Renfert Waxlectric I Manual De Instrucciones

6

Cleaning / Maintenance

Never rinse the unit off with water!
Do not use steam to clean the unit! Hot steam penetrating the unit can damage it.
⇒ Use a soft, lint-free cloth to wipe the unit down from time-to-time�
Never use cleansers containing solvents!
⇒ Wipe the tips off after use; This will prevent wax from burning onto the tip and maintain the tip's optimal
heat conducting properties�
6.1 Changing Tips
Burn hazard!
The modelling tips may be hot. Always allow the tips to cool before changing them.
• Unscrew the tip (Fig� 11)�
• Make sure the O-ring is properly seated (Fig� 12)�
• When the tip is brand new, ensure that the contacts are clean�
• Insert the new tip, making sure it is straight, and hand-tighten it� Make sure the tip IS NOT skewed or
cross-threaded (Fig�1)�
Make sure the O-ring is properly seated (Fig. 12), the O-ring provides a seal against the wax.
Modelling tips which are not being used can be safely and handily stored in the tip holder (Fig� 8)�
6.2 Changing the cork sleeve
⇒ Unscrew the tip (Fig� 11)�
⇒ Pull the cork sleeve off towards the front (Fig� 13)�
⇒ Install a new cork sleeve, making sure it is straight (Fig� 14)�
⇒ Screw the tip back on (Fig� 1)�
6.3 Cleaning the Quiver and Tip Holder
The tip holder and quiver can be easily removed for cleaning�
• Tip holder:
Press gently from the side (Fig. 15), then flip upwards and pull off towards the rear (Fig. 16).
• Quiver:
Rotate the quiver downwards and towards the rear to remove it (Fig� 17)�
Remount tip holder and quiver in reverse order�
6.4 Spare Parts
You can find components subject to wear and the spare parts on the spare part
list in the internet at www.renfert.com/p918�
Enter the following item number: 21560000 / 21570000
The components excluded from the warranty (such as consumables or parts sub-
ject to wear and tear) are marked on the spare part list�
Serial number and date of manufacturing are shown on the type plate of the unit�
- 9 -
EN