Wayne Dalton 8000 Manual Del Usuario página 10

5
NOTE: For door section identification see page 4.
Tools Needed:
Power Drill
Align the center hole of bottom bracket with hole #3
7/16" Socket Driver
in the end stile of the bottom section.
Refer to the u-bar schedule to determine if the
bottom section requires a u-bar. If the bottom section
requires a u-bar, position the u-bar over the bottom
brackets and center the u-bar side to side on the
bottom section.
Attaching bottom brackets without a u-bar: Attach
the bottom bracket to the end stile using (2) 1/4"-20
x 7/8" self drilling screws and (1) 1/4"-20 x 5/8"
tamper-resistant self drilling screw as shown. Repeat
for other side.
Attaching bottom brackets with a u-bar: Attach
the bottom bracket with (1) 1/4"-20 x 7/8" self
tamper-resistant drilling screw, and then secure the
u-bar / bottom bracket into the endstile using (2)
1/4"-20 x 5/8" self drilling screw. Repeat for other
side. Now, finish securing the u-bar to the section
using (2) 1/4"-20 x 7/8" self drilling screws at each
end and center stile location.
NOTE: All doors are provided with the tamper
resistant fastener for the bottom brackets. However,
the professional installer is most likely to have the
proper tool to install this fastener. If the homeowner
does not have the proper tool to install the tamper
resistant fastener, use a regular 1/4 - 14 x 7/8" self
drilling screw in its place.
For windload specification option codes
1124, 1125, 1142 and 1144: Extension brackets
and long shaft rollers are required. Position the
extension bracket flush against the end stile and
slide it underneath the u-bar (if applicable). Align
the extension bracket with the bottom bracket by
inserting a long shaft roller with spacer through the
bottom bracket and extension bracket hinge tubes.
Attach the extension bracket to the endstile with (2)
1/4" -20 x 7/8" self drilling screws as shown. Repeat
for other side.
10
Please Do Not Return This Product To The Store. Contact your local Wayne Dalton dealer. To find your local Wayne Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com.
Bottom Bracket
U-Bar Schedule
Position
Door Height Section on
section
6'- 0" to 8'- 0"
Bottom Bottom
1
2
3
4
5
6
#3
Hole
Bottom
7
bracket
(1) 1/4"- 14 x 5/8"
Self drilling tamper-resistant
screw
7
6
5
4
3
2
1
#3
Hole
Bottom
bracket
END STILE HOLE
PATTERN (LEFT SIDE
(1) 1/4"- 14 x 5/8"
IS SHOWN. RIGHT
Self drilling tamper-resistant screw
SIDE IS OPPOSITE.)
Stile
Bottom
section
Bottom
Bracket
Hinge tubes of
bottom bracket
Spacer
Long shaft roller
1104 / 1123 / 1124 / 1125 /1142 / 1143 / 1144
X
Warning
label
End Stile
(2) 1/4"- 14 x 7/8"
Self drilling screws
(A)
End
Stile
Warning
label
Bottom
section
(2) 1/4"- 14 x 7/8"
Self drilling screws
(B)
(2) 1/4"- 14 x 7/8"
Self drilling screws
U-bar
Hinge tube
of extension
bracket
(C)
Bottom
section
U-bar