Door Section Identification; Warning Label - Wayne Dalton 8000 Manual Del Usuario

Package contents continued...
3/8"- 16 Hex nuts 1/4"- 20 Hex nuts
(as required) (as required)
(2) 5/16" - 18 x 3/4" 1/4"- 14 x 7/8" Self drilling screws
Carriage Bolts
1/4"- 20 x 11/16" Self
drilling screws (as required)
(2) 1/4" x 2-1/2" Carriage bolts

Door Section Identification

Door Height Bottom
6'0" 18"
6'6" 21"
7'0" 21"
7'6" 18"
8'0" 21"

WARNING LABEL

INTERMEDIATE I SECTION
BOTTOM BRACKET
WARNING LABELS
ASTRAGAL
BOTTOM SECTION
4
Please Do Not Return This Product To The Store. Contact your local Wayne Dalton dealer. To find your local Wayne Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com.
5/16"- 18 Hex nuts
(as required)
(as required)
(4) 1/4" - 20 x 5/8"
Carriage bolts
Lock (second)
18"
18"
21"
18"
18"
1/4"- 20 Flange hex nuts
(as required)
3/8"- 16 x 3/4" Truss head
bolts (as required)
5/16" X 1 5/8" Hex head lag
screws (as required)
Intermediate (third) Intermediate II (fourth)
18" NA
18" NA
21" NA
18" 18"
18" 18"
When installing your door you must use sections of the
appropriate height in the right stacking location. What
sections heights you need to use in what order depends on
the height of your door.
18"
Unless your door is five sections in height, you will not
receive an Intermediate II section.
The BOTTOM SECTION can be identified by the factory
attached bottom astragal, or by the bottom bracket
warning labels on each end stile.
The INTERMEDIATE I SECTION may have a warning label
attached to either right or left hand endstile of the section.
21"
This section is always the 3rd section from the bottom of
the door.
(2) 1/4"- 14 X 5/8"
Tamper resistant screws
1/4"- 20 X 9/16" Track
Bolts (as required)
3/8"- 16 X 1-1/4" HEX HEAD
BOLTS (AS REQUIRED)
(2) 1/4" x 2-3/4" Carriage bolts
Top
18"
21"
21"
18"
21"