Wayne Dalton 8000 Manual Del Usuario página 24

21
Attaching Extension Springs
Tools Needed:
Position the (1) 5/16" - 18 x 3-3/4"
eyebolt and (1) 5/16" - 18 hex nut in
the rear support, 6" to 8" above the
horizontal track.
Feed the snubber cable through the rear
support and tie the special knot around
the "room side" of the 3 hole clip as
shown.
Secure the eyebolt and clip to the rear
support with (1) 5/16" - 18 hex nut.
Hook one end of the extension spring
onto the eyebolt.
Feed the snubber cable through the end
spring loop and center of the extension
spring then front spring loop, pull the
snubber cable taut and tie the special
knot around the "jamb side" of the 3
hole clip.
Attach the "jamb side" 3 hole clip to the
jamb near the flagangle with
(1) 5/16" x 1-5/8" lag bolt.
23
NOTE: Snubber cables must be taut.
WARNING
FAILURE TO INSTALL SNUBBER
CABLES CAN RESULT IN SEVERE
INJURY OR DEATH IN CASE OF
SPRING BREAKAGE.
24
Please Do Not Return This Product To The Store. Contact your local Wayne Dalton dealer. To find your local Wayne Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com.
5/16"- 18
5/16"- 18 X 3-3/4"
HEX NUT
EYEBOLT
HORIZONTAL TRACK
SNUBBER
CABLE
EYEBOLT
ASSEMBLY
SPRING
SNUBBER
LOOP
CABLE
5/16" X 1-5/8"
LAG BOLT
SNUBBER
CABLE
6" - 8"
SPECIAL
KNOT
SPECIAL KNOT
3 HOLE
CLIP
5/16"- 18
HEX NUT
SPRING
LOOP
SPECIAL KNOT-BACK
SPECIAL KNOT-FRONT
SNUBBER
CABLE
SPRING
LOOP