Wayne Dalton 8000 Manual Del Usuario página 12

Place the hinges on the section so that the lower (#)
Tools Needed:
leaf of the hinge is over the pre-punched holes in
the #1 and #4 of the end stiles and the pre-punched
holes of the center stile(s) at the top of the section.
Secure the hinges to the section using (2) 1/4" - 14
x 7/8" self tapping screws for each, then insert the
roller into the appropriate end hinge tube.
NOTE: The #1 hinges serve as end hinges and center
hinges on the bottom section. The #1 hinges also
serve as center hinges at all center hinge locations.
Use #2 end hinges and #1 center stile hinges for the
lock section (second section) of the door.
Use #3 end hinges and #1 center stile hinges for the
intermediate section (third section) of the door.
Use #4 end hinges and #1 center stile hinges for the
intermediate section II (fourth section) of the door.
IMPORTANT: WHEN PLACING ROLLERS INTO END
HINGES NUMBER 2 AND HIGHER, THE ROLLER GOES
INTO TUBE FURTHEST AWAY FROM SECTION.
NOTE: #4 End hinges are used on fourth section of
five section doors.
12
Please Do Not Return This Product To The Store. Contact your local Wayne Dalton dealer. To find your local Wayne Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com.
Hinges Continued... Narrow end hinge
Short shaft
roller
1
End stile
(2) 1/4"- 14 x 7/8"
Self drilling screws
(A) NARROW END HINGE INSTALLATION
Center
stile
(A OR B) NARROW CENTER HINGE INSTALLATION
Center
stile
(C) WIDE CENTER HINGE INSTALLATION
Previously installed
Wide end hinge
Long shaft roller
Stile
Wide end hinge
Short shaft
roller
1
End stile
(2) 1/4"- 14 x 7/8"
Self drilling screws
(B OR C) WIDE END HINGE INSTALLATION
(2) 1/4"- 14 x 7/8"
Self drilling screws
1
Narrow
center hinge
(2) 1/4"- 14 x 7/8"
Self drilling screws
Wide center
hinge
Wide end hinge
1
1
(2) 1/4"- 14 X 7/8"
Self drilling screws
(C)