Side Lock; Pull Rope - Wayne Dalton 8000 Manual Del Usuario

D
Install the side lock on the second section of the door.
Tools Needed:
Square the lock assembly with the door section and
Power Drill
align with the square hole in the vertical track. The
side lock should be spaced approximately 1/8" in
7/16" Socket Driver
from the section edge. Secure the lock to the section
Tape Measure
with (4) 1/4"- 20 x 11/16" self drilling screws.
IMPORTANT: SIDE LOCKS MUST BE REMOVED OR
MADE INOPERATIVE IN THE UNLOCKED POSITION IF
AN OPERATOR IS INSTALLED ON THE DOOR.
NOTE: After completing this step, continue with Step
15 on page 18.
D
WARNING
Tools Needed:
Power Drill
DO NOT INSTALL PULL ROPES ON DOORS WITH
Drill Bit
ELECTRIC OPERATORS. CHILDREN MAY BECOME
ENTANGLED IN THE ROPE CAUSING SEVERE OR FATAL
INJURY.
Pilot drill the location for the No. 6 screw eye.
Screw the No. 6 screw eye into the wood jamb
approximately 48" to 50" (1220 to 1270 mm) from
the floor. Tie the pull rope to the screw eye and to the
bottom bracket as shown.
Please Do Not Return This Product To The Store. Contact your local Wayne Dalton dealer. To find your local Wayne Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com.

Side Lock

No. 6 screw eye

Pull Rope

Pull rope
(4) 1/4"- 20 X 11/16"
self drilling screws
Pull rope
1/8"
Bottom
bracket
27