Wayne Dalton 8000 Manual Del Usuario página 23

20
Attaching Front Sheaves
Using (1) 3/8" - 16 hex nut, attach the
Tools Needed:
None
front steel sheave in the appropriate
hole (left hand shown).
3" STEEL SHEAVE WITH 12" RADIUS
TRACK:
Bolt the sheave to the 13/32" hole near
the top of the flagangle.
3" OR 4" STEEL SHEAVE WITH 15"
RADIUS TRACK:
Bolt the sheave to the first 13/32" hole
in the horizontal angle.
Repeat for other side.
Remove the locking pliers from the
vertical tracks. With assistance, raise
the door slowly into the open position
making sure the door travels smoothly
through the track.
22
Clamp locking pliers to the back leg of
both horizontal tracks, below the bottom
rollers to keep the door from lowering.
Please Do Not Return This Product To The Store. Contact your local Wayne Dalton dealer. To find your local Wayne Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com.
STEEL
SHEAVE
FLAGANGLE
3/8- 16"
HEX NUT
12" RADIUS TRACK
WITH 3" STEEL SHEAVE
HOLE LOCATION
15" RADIUS TRACK WITH
3" OR 4" STEEL SHEAVE
HOLE LOCATION
HORIZONTAL
ANGLE
23