Sirona CEREC MC XL Manual Del Usuario página 73

Sirona Dental Systems GmbH
Operating MC XL via WLAN in the Ad-hoc mode CEREC / inLab MC XL
Switching the units off and on again
Switching the units off and on again
Changing channels
61 90 545 D 3439
D 3439.031.03.01.02 06.2007
Fig. 4-7 Ad-hoc mode advanced settings
Change the WLAN channel in the "Channel" field and confirm with
6.
"OK".
The channel change of the acquisition unit (with CISCO WLAN card)
is completed.
1. Power down the PC.
2. Switch the acquisition unit and the milling unit off and on again.
3. Analyze the connection quality with the newly set WLAN channel as
described in the chapter entitled "Analyzing connection quality" [ 26].
4.4.2.2 Changing channels on the LINKSYS WLAN card
1. Double-click the LINKSYS icon on the toolbar.
The following window appears. Its contents may vary depending on
the preconfiguration and/or the hardware version of the PC.
4 Final work
Changing channels in the Ad-hoc mode
33