Analyzing Connection Quality - Sirona CEREC MC XL Manual Del Usuario

4 Final work

Analyzing connection quality

Performing the communication test
Performing the communication test
26
Operating MC XL via WLAN in the Ad-hoc mode CEREC / inLab MC XL
4.3 Analyzing connection quality
The PC and the milling unit are switched off.
1. Position the PC near the milling unit (1-2 m away).
2. Switch the PC and the milling unit on.
CAUTION: Use only the test
The service software is intended as a resource for the service engineer. Not
having been trained as a service engineer, you should use only the described
test for the serial communication.
1. Open the Service menu as follows.
CEREC MC XL:
"Start"/"Programs"/"CEREC"/"Service"
inLab MC XL:
"Start"/"Programs"/"inLab"/"Service"
The Service Login dialog box then opens for password entry.
Enter the current month and day backwards in the "Password" field.
2.
Example: 05/24/2007 => 5042
Confirm your selection with the "Yes" button.
3.
4. If several milling units are connected, a dialog box will appear. Select the
language you prefer and confirm your choice with "OK".
The "Test selection" dialog box appears.
Sirona Dental Systems GmbH
"Serial communication"
61 90 545 D 3439
D 3439.031.03.01.02 06.2007