Connecting The Power Cord - Pioneer AVH-P4000DVD Manual De Instalación

Connecting the units

Connecting the power cord

Note:
Depending on the kind of vehicle, the
function of 3* and 5* may be different. In
this case, be sure to connect 2* to 5* and
4* to 3*.
3*
5*
Cap (1*)
Do not remove cap if this
terminal is not in use.
Yellow (3*)
Back-up
(or accessory)
Red (5*)
Accessory
(or back-up)
Orange/white
Connect to lighting switch terminal.
Black (chassis ground)
Connect to a clean, paint-free metal location.
ISO connector
Note:
In some vehicles, the ISO connector may be
divided into two. In this case, be sure to connect
to both connectors.
When you connect the separately sold
multi-channel processor (e.g., DEQ-P6600) to
this unit, do not connect anything to the
speaker leads and system remote control
(blue/white).
6
1*
2*
4*
Yellow (2*)
Connect to the constant 12 V
supply terminal.
Red (4*)
Connect to terminal controlled by
ignition switch (12 V DC).
This product
Antenna input
Fuse (10 A)
Connect leads of the same
color to each other.
Fuse resistor
Fuse resistor
Speaker leads
Front left 
White:
White/black: Front left 
Front right 
Gray:
Front right 
Gray/black:
Rear left  or subwoofer 
Green:
Green/black: Rear left  or subwoofer 
Rear right  or subwoofer 
Violet:
Rear right  or subwoofer 
Violet/black: