Before Connecting; Replacing Headlamp Bulbs; Combustion Engine - Stihl RT 5097.1 Manual De Instrucciones

Avoid damage to the machine!
Never charge the battery when the
engine is running.
Only the STIHL ACB 010 battery
float charger or the STIHL ADL 012
diagnostic charger may be
connected to the charger plug.
Other chargers, particularly those
with a higher charging current, can
damage the machine.
In order to charge the battery using
another chargers, it must first be
removed.

Before connecting:

● Read and observe the information in
the instruction manuals for the STIHL
chargers.
● Read and observe the instructions in
the battery supplementary sheet.
Connecting:
● Stop the engine. ( 13.3)
● Engage the parking brake. (
● Open the engine hood. (
58
Only connect the STIHL ACB 010 battery
float charger or the STIHL ADL 012
diagnostic charger to the charger plug (1).

15.22 Replacing headlamp bulbs

When replacing defective lamp
bulbs, always use 12V bulbs rated
at 6W.
Bulb designation:
12V 6W BA9s
● Open the engine hood. (
8.14)
15.3)
Turn the socket (1) through approx. 90°
and it pull out.
15.3).
Press the bulb (2) in the direction of the
socket (1) and hold. Carefully turn the
bulb (2) and remove.
● Install the bulb in reverse order.
Push the socket (1) into the headlamp
housing.
● Close the engine hood. (

15.23 Combustion engine

Observe the operating and maintenance
instructions contained in the attached
engine instruction manual.
15.4)
0478 192 9813 C - EN