Stihl RT 5097.1 Manual De Instrucciones página 42

Slackening the V-belt (RT 5097,
RT 5097 Z):
Pull the tension spring (1) forwards,
detach and set down.
Slackening the V-belt (RT 5112 Z,
RT 6112 ZL, RT 6127 ZL):
Detach the retainer (1) from the V-belt
tensioner lever.
40
Press the V-belt tensioner lever (1)
forwards and hold. Engage the retainer (2)
at the frame as shown. Make sure that the
V-belt tensioner lever is fixed in the front
position.
Detaching the mowing deck at the rear:
Risk of injury!
The cutting height adjustment lever
is under tension when the mowing
deck is detached. Therefore
carefully set the highest cutting
level immediately after detaching
the mowing deck.
Pull out the cotter pin (1) upwards.
Lift up the mowing deck slightly and hold.
Push the mounting (2) outwards and
remove the retaining pin (3) from the
mounting.
● Repeat this procedure on the other
side.
● Carefully and slowly set down the
mowing deck.
Detaching the V-belt:
Press the retaining plate (1) forwards and
hold. Pull the V-belt (2) forwards and
detach.
0478 192 9813 C - EN